Ford Mustang Service Manual: Removal

Removal

Both mounts

1. Disconnect the battery ground cable. For additional information, refer to Section.

2. Remove the coolant bypass tube. For additional information, refer to Section.

3. Rotate the drive belt tensioner clockwise and detach the drive belt from the generator pulley.

4. Disconnect the generator electrical connections.


4. Disconnect the generator electrical connections.

5. Remove the bolts and the generator.


5. Remove the bolts and the generator.

6. Install the special tool.


6. Install the special tool.

7. Using the special tool, support the engine.


7. Using the special tool, support the engine.

8. Remove the front springs. For additional information, refer to Section.


8. Remove the front springs. For additional information, refer to Section.

9. NOTE

: RH shown, LH similar.

Remove the six splash-shield pushpins.

10. Remove the 13 bolts and the cross-brace support.


10. Remove the 13 bolts and the cross-brace support.

11. NOTE: RH shown, LH similar.


11. NOTE

: RH shown, LH similar.

Remove the two engine mount nuts.

12. Using two jackstands, support the subframe.


12. Using two jackstands, support the subframe.

13. NOTE: Mark the bolts and the crossmember location for assembly reference.


13. NOTE

: Mark the bolts and the crossmember location for assembly reference.

NOTE:

RH shown, LH similar.

Remove the four bolts.

14. NOTE: RH shown, LH similar.


14. NOTE

: RH shown, LH similar.

Remove the four bolts.

15. Using the jackstands, lower the front subframe.


15. Using the jackstands, lower the front subframe.

RH mount

16. Remove the nut and detach the wiring harness.

17. Remove the bolts, the studbolt and the engine mount.


17. Remove the bolts, the studbolt and the engine mount.

LH mount


LH mount

18. Remove the nuts and detach the ground cables.

19. Remove the bolt, the studbolts and the engine mount.


19. Remove the bolt, the studbolts and the engine mount.

Installation


    Engine Mount
    Engine WARNING: Do not operate the engine with the hood open until the fan blade has been first examined for possible cracks and separation. The 4.6L (4V) (281 CID) is a V-8 engine with the follow ...

    Installation
    Removal Both mounts 1. Disconnect the battery ground cable. For additional information, refer to Section. 2. Remove the coolant bypass tube. For additional information, refer to Section. 3. Rotate ...

    Other materials:

    Steering Column Shaft
    Steering Column (Description and Operation)   NOTE: All fasteners are important because they can affect the performance of vital parts and systems. Incorrect installation of the fasteners can result in major repair expenses. They must be installed ...

    Child restraint and safety belt maintenance
    Inspect the vehicle safety belts and child safety seat systems periodically to make sure they work properly and are not damaged. Inspect the vehicle and child seat safety belts to make sure there are no nicks, tears or cuts. Replace if necessary. All vehi ...

    Seat Track
    Seats (Description and Operation)   Seats - Front Power The front power seat features: a six-way seat regulator control switch (14A701) located on the front of the seat. a seat track (61705) mounted under the seat. a seat regulator motor ( ...