Ford Mustang Service Manual: Removal

Removal

1. Remove the roller followers. For additional information, refer to Roller Followers in this section.

2. Remove the spark plugs. For additional information, refer to Section .

3. Position the piston of the cylinder being serviced at the bottom of the stroke.

4. CAUTION: If air pressure has forced the piston to the bottom of the cylinder any loss of air pressure will allow the valve to fall into the cylinder. If air pressure must be removed support the valve prior to removal.

Use compressed air in the cylinder to hold both valves in position.

5. Using the special tool, compress the intake valve spring.


5. Using the special tool, compress the intake valve spring.

6. NOTE: Valve stem seals should be visually inspected if new seals are not


6. NOTE

: Valve stem seals should be visually inspected if new seals are not installed.

Remove the valve spring retainer keys, the valve spring retainer, the valve spring and the valve stem seal.

7. Using the special tool, compress the exhaust valve spring.


7. Using the special tool, compress the exhaust valve spring.

8. NOTE: Valve stem seals should be visually inspected if new seals are not


8. NOTE

: Valve stem seals should be visually inspected if new seals are not installed.

Remove the valve spring retainer keys, the valve spring retainer, the valve spring and the valve stem seal.

Installation


    Valve - Springs, Retainer and Valve Stem Seal
    Engine WARNING: Do not operate the engine with the hood open until the fan blade has been first examined for possible cracks and separation. The 4.6L (4V) (281 CID) is a V-8 engine with the follow ...

    Installation
    Removal 1. Remove the roller followers. For additional information, refer to Roller Followers in this section. 2. Remove the spark plugs. For additional information, refer to Section . 3. Position ...

    Other materials:

    Transmission (Installation)
    Manual Transmission The T56 six-speed manual transmission features the following: six forward speeds and one reverse speed. forward gears are synchronized and helical cut. a reverse gear operates through a constant-mesh, fully synchronized system. a shi ...

    Changing a road wheel
    WARNING: The use of tire sealants may damage your tire pressure monitoring system and should not be used. However, if you must use a sealant, have an authorized dealer install a new tire pressure monitoring system sensor and valve stem. WARNING: See Tire ...

    Wipers and Washers (Diagnosis and Testing)
    Wipers and Washers (Diagnosis and Testing) Refer to Wiring Diagrams Cell 59 , Generic Electronic Module for schematic and connector information. Refer to Wiring Diagrams Cell 81 , Interval Wiper/Washer for schematic and connector information. Sp ...