Ford Mustang Service Manual: Rear Subframe

Removal and Installation

CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part number must be installed if installation becomes necessary. Torque values must be used as specified during reassembly.

1. Remove the rear coil springs. For additional information, refer to Section.

2. Using the special tool, raise the rear subframe.

3. Remove and discard the rear subframe front bolts.

4. Using the special tool, lower and remove the rear subframe.


4. Using the special tool, lower and remove the rear subframe.

5. NOTE: Discard the old bolts and nuts. Do not reuse, install new bolts and nuts.

To install, reverse the removal procedure.

Subframe Support -Convertible

Removal and Installation

1. Raise and support the vehicle. For additional information, refer to Section.

2. Support the front subframe support.

3. Remove the RH front subframe support bolts.

4. Remove the LH front subframe support bolts.


4. Remove the LH front subframe support bolts.

5. Remove the front subframe support.


5. Remove the front subframe support.

  • Remove the bolts and lower the front subframe support.

6. To install, reverse the removal procedure.


6. To install, reverse the removal procedure.

    Front Subframe - 4.6L (4V) Engine
    Special Tool(s) 3-Bar Engine Support Kit 303-F072 Lifting Bracket, Engine 303-D088 (D93P-6001-A2) Removal and Installation All vehicles 1. Remove the steering gear. For a ...

    General Information
    INTRODUCTION In the past, when cars were simpler, diagrams were simpler. All components were connected by wires, and diagrams seldom exceeded 4 pages in length. Today, some wiring diagrams require m ...

    Other materials:

    Engine Coolant Temperature (ECT) Sensor - Cobra
    Electronic Engine Controls (Description and Operation) The electronic engine controls consist of the following: powertrain control module (PCM) throttle position (TP) sensor idle air control (IAC) valve engine coolant temperature (ECT) sensor ...

    Bar - Stabilizer
    Wheel Studs Removal 1. Remove the wheel hub (1104). For additional information, refer to Wheel Hub and Bearing in this section. 2. Using a press, remove the wheel stud (1107) from the wheel hub. Installation 1. Using a press, install a new wheel stud. 2. I ...

    Fuel Charging Wiring Harness
    Fuel Charging And Controls The fuel injection supply manifold (9F792): delivers fuel to the fuel injector. receives fuel from the fuel supply line. The throttle body (9E926): controls air supply to the upper intake manifold (9424) by positioning the th ...