Ford Mustang Service Manual: Rear Drive Axle/Differential - Ford 8.8-Inch IRS
General Specifications
Torque Specifications
a: Use Stud and Bearing Mount EOAZ-19554-BA or equivalent meeting Ford specification WSKM2G349- A1.
b: With pinion flange yoke seal.
- Rear Drive Axle and Differential
- Stub Shaft Pilot Bearing and Seal
- Drive Pinion Flange
- Pinion Seal
- Axle Housing
- Axle
Assembly
Disassembly
1. Remove the differential assembly from the differential housing. For
additional information, refer
to Differential Case in this section.
2. Remove the 10 bolts.
3. CAUTION: Do not da ...
Rear Drive Axle and Differential
Rear Drive Axle and Differential
The differential housing (4010) consists of a cast aluminum housing and
a cast aluminum
differential housing cover (4033). The differential housing c ...
Other materials:
Installation
Removal
1. Remove the upper intake manifold. For additional information, refer to
Upper Intake Manifold in
this section.
2. Partially drain the cooling system. For additional information, refer to
Section.
3. Relieve the fuel system pressure. For add ...
Rear Spoiler
Moulding - Roof Side
Removal and Installation
1. Remove the weatherstrip.
2. Remove the exterior roof side moulding screws.
3. Remove the interior roof side moulding screws.
4. Remove the roof side moulding screw.
5. Release the clips.
1. Lif ...
Pinpoint Tests - Air Bag Supplemental Restraint System
(SRS)
Air Bag Supplemental Restraint System (SRS) (Description and Operation)
The air bag supplemental restraint system (SRS) is designed to provide
increased collision protection
for front seat occupants in addition to that provided by the three-point safety
belt ...