Ford Mustang Service Manual: Keyless Entry/Computer Operated Locks

Programming -Keyless Entry Remote Transmitter

NOTE: All keyless entry remote transmitters (15K601) must be programmed at the same time.

NOTE: All previous transmitter identification codes (TIC's) will be erased when programming mode is entered.

NOTE: To program (or reprogram) the keyless entry remote transmitters into the generic electronic module (GEM)(14B204), perform the following steps.

1. Turn the ignition from OFF to RUN eight times within 10 seconds, ending in RUN. If the GEM has successfully entered program mode, it will lock and unlock all the doors.

2. NOTE: The first TIC must be entered within 7.5 seconds of entering the program mode and additional TICs must be entered within 7.5 seconds of the first TIC. The programming mode is exited whenever the timing constraints are not met.

Press any button on a keyless entry remote transmitter, and the doors will lock and then unlock to confirm that each keyless entry remote transmitter has been programmed.

3. If the door locks do not respond for any keyless entry remote transmitter, wait for several seconds and press the button again.

4. Turn the ignition switch to the OFF position, or wait up to five minutes after step 1, to exit program mode. If a keyless entry remote transmitter has been programmed (or reprogrammed), the GEM will lock and unlock all the doors one last time.

 

    Inspection and Verification
    Principles of Operation NOTE: Battery power and ground must be remove before disconnecting the GEM connectors to avoid setting false codes. Power Locks Operation The power locks feature all ...

    Wipers and Washers
    General Specifications Torque Specifications Wipers and Washers The wiper and washer system consists of the following components: windshield wiper mounting arm and pivot shaft pivot arms ...

    Other materials:

    Differential Case and Ring Gear - Traction-Lok
    Rear Drive Axle and Differential   The axle housing assembly consists of a cast center section with two steel tube assemblies and a stamped differential housing cover (4033). The differential housing cover uses silicone sealant as a gasket. ...

    Pinpoint Test O: DTC B1870 - Air Bag Indicator Shorted to Battery
    Pinpoint Test A: The Air Bag Warning Indicator Is Illuminated Continuously - RCM Disconnected, Inoperative or Lost/Low Ignition Feed Normal Operation NOTE: During normal operation the air bag indicator will be lit continuously for 6 seconds after the ignitio ...

    Pinion Seal
    Rear Drive Axle and Differential   The differential housing (4010) consists of a cast aluminum housing and a cast aluminum differential housing cover (4033). The differential housing cover uses silicone sealant as a gasket. The hypoid-desig ...