Ford Mustang Service Manual: Installation

Removal

Both mounts

1. Disconnect the battery ground cable. For additional information, refer to Section.

2. Remove the coolant bypass tube. For additional information, refer to Section.

3. Rotate the drive belt tensioner clockwise and detach the drive belt from the generator pulley.

4. Disconnect the generator electrical connections.


4. Disconnect the generator electrical connections.

5. Remove the bolts and the generator.


5. Remove the bolts and the generator.

6. Install the special tool.


6. Install the special tool.

7. Using the special tool, support the engine.


7. Using the special tool, support the engine.

8. Remove the front springs. For additional information, refer to Section.


8. Remove the front springs. For additional information, refer to Section.

9. NOTE

: RH shown, LH similar.

Remove the six splash-shield pushpins.

10. Remove the 13 bolts and the cross-brace support.


10. Remove the 13 bolts and the cross-brace support.

11. NOTE: RH shown, LH similar.


11. NOTE

: RH shown, LH similar.

Remove the two engine mount nuts.

12. Using two jackstands, support the subframe.


12. Using two jackstands, support the subframe.

13. NOTE: Mark the bolts and the crossmember location for assembly reference.


13. NOTE

: Mark the bolts and the crossmember location for assembly reference.

NOTE:

RH shown, LH similar.

Remove the four bolts.

14. NOTE: RH shown, LH similar.


14. NOTE

: RH shown, LH similar.

Remove the four bolts.

15. Using the jackstands, lower the front subframe.


15. Using the jackstands, lower the front subframe.

RH mount

16. Remove the nut and detach the wiring harness.

17. Remove the bolts, the studbolt and the engine mount.


17. Remove the bolts, the studbolt and the engine mount.

LH mount


LH mount

18. Remove the nuts and detach the ground cables.

19. Remove the bolt, the studbolts and the engine mount.


19. Remove the bolt, the studbolts and the engine mount.

Installation


    Removal
    Removal Both mounts 1. Disconnect the battery ground cable. For additional information, refer to Section. 2. Remove the coolant bypass tube. For additional information, refer to Section. 3. Rotate ...

    Engine (Removal)
    Engine WARNING: Do not operate the engine with the hood open until the fan blade has been first examined for possible cracks and separation. The 4.6L (4V) (281 CID) is a V-8 engine with the follow ...

    Other materials:

    Electronic compass
    The compass heading displays in the center-integrated display. Note: Driving near large buildings, bridges, power lines and powerful broadcast antenna may affect the compass reading. Magnetic or metallic objects placed in, on or near your vehicle may also ...

    Installation
    Removal 1. Disconnect the electrical connectors from the EGR vacuum regulator solenoid, the supercharger bypass vacuum solenoid, and the differential pressure feedback EGR system. 2. Disconnect the vacuum hoses from the differential pressure feedba ...

    Inspection and Verification
    Inspection and Verification WARNING: A vehicle equipped with a Traction-Lok differential will always have both wheels driving. If, while the vehicle is being serviced, only one wheel is raised off the ground and the rear axle is driven by the engine, the whe ...