Ford Mustang Service Manual: Engine - Mach I 4.6L (4V)

General Specifications

Engine Specifications


Engine Specifications




a - Newly Installed-Refers to the condition of the


a - Newly Installed-Refers to the condition of the "NEW" drive belt before the engine has made no more than one rotation and before the belt has had a chance to stretch or seat into the pulley grooves.

c - P=Primary, S=Secondary, E=Exhaust.

d - Time necessary for plunger to leak down 1.6 mm of travel with 222 N force and leak down fluid in tappet.

e - Distance front edge of bearing is installed below front face of cylinder block.

f  - 0.050 Undersize-add 0.025 to standard thickness.

g - Pin bore and crank bearing bore must be parallel and in same vertical plane within the specified total difference when measured at the ends of a 203 mm bar, 101.5 mm on each side of rod centerline.

h - Cylinder Bore Diameter

Red-90.200-90.213

Blue-90.213-90.226

Yellow-90.226-90.239

i - Measured at 42 mm from piston dome, at 90 degrees to the piston pin.

j - Piston pin outer diameter is larger than piston pin bore, providing a possible interference fit.

k -Specification in 90.200 mm diameter gauge.

l  -With installation of a new filter.

Drive Belt Tension

a -


a - "Fixed" refers to systems with manually-adjusted centers which are bolted in place and considered fixed.

Torque Specifications


a - Refer to the procedure.


a - Refer to the procedure.

Engine (Installation)
Engine (Description and Operation) WARNING: Do not operate the engine with the hood open until the fan blade has been first examined for possible cracks and separation. The 4.6L (4V) (281 CID) Cobra ...

Engine
Engine WARNING: Do not operate the engine with the hood open until the fan blade has been first examined for possible cracks and separation. The 4.6L (4V) (281 CID) is a V-8 engine with the follow ...

Other materials:

Tracer Dye Leak Detection
Climate Control System (Description and Operation) WARNING: To avoid accidental deployment and possible injury, the air bag system backup power supply must be depleted before repairing any climate control components. To deplete the backup power supply, disco ...

Fuel Charging And Controls
Fuel Charging And Controls The fuel injection supply manifold (9F792): delivers fuel to the fuel injector. receives fuel from the fuel supply line. The throttle body (9E926): controls air supply to the upper intake manifold (9424) by positioning the th ...

Intake Manifold
Engine       A modular engine is built around four modules: the intake module the cylinder head module (RH) the cylinder head module (LH) the lower engine module While not all repairs can take advantage of the modular conc ...