Ford Mustang Service Manual: Door - Air Inlet Duct
NOTE: The air distribution system of this vehicle cannot be equipped with a cabin air filter.
There are two sources of air available to the air distribution system:
- outside air
- recirculated air
Recirculated air is only used during MAX A/C.
Air distribution within the vehicle is determined by the function selector switch position. Airflow control doors are used to direct airflow within the air plenum chamber. Vacuum control motors (18A318) are used to position these airflow control doors. Refer to Section for a description and operation of each of the system functions.
The air distribution system is designed to provide airflow from the defrost nozzle when no vacuum is applied to any of the vacuum control motors. This is done to prevent a situation where defrost cannot be obtained due to a system vacuum leak.
Air enters the passenger compartment from the:
- instrument panel A/C register (19893).
- heater outlet floor duct (18C433).
- windshield defroster hose nozzle (18490).
- side window demisters.
Passenger compartment air is exhausted from the vehicle through open windows or body air vents.
Instrument Panel Registers
There are A/C registers on the left and right sides of the instrument panel and in the center instrument panel finish panel.
The LH and RH A/C registers are only serviceable as assemblies.
The center A/C registers are not serviceable as assemblies. The registers are installed with the instrument panel center finish panel assembly.
Front Seat Cushion
Seats (Description and Operation) Seats - Front Power The front power seat features: a six-way seat regulator control switch (14A701) located on the front of the seat. a seat track (61705) mounted under the seat. a seat regulator motor ( ...
Inspection and Verification CAUTION: Do not hold the steering wheel (3600) at the stops for an extended amount of time. Damage to the power steering pump (3A674) will result. NOTE: Make the following preliminary checks before repairing the steering system: ...
Rear Drive Axle and Differential
Rear Drive Axle and Differential The axle housing assembly consists of a cast center section with two steel tube assemblies and a stamped differential housing cover (4033). The differential housing cover uses silicone sealant as a gasket. ...