Ford Mustang Owners Manual: Axle information

Traction-Lok™ Axle (If Equipped)

This axle provides added traction on slippery surfaces, particularly when one wheel is on a poor traction surface. Under normal conditions, the Traction-Lok™ axle functions like a standard rear axle.

Extended use of other than the manufacturer’s specified size tires on a Traction-Lok™ rear axle could result in a permanent reduction in effectiveness. This loss of effectiveness does not affect normal driving and should not be noticeable to the driver.

Axle with TORSEN® Differential (If Equipped)

This axle provides added traction on slippery surfaces, particularly when one wheel is on a poor traction surface. Under normal conditions, the axle equipped with a TORSEN® differential functions like a standard rear axle.

Extended use of other than the manufacturer’s specified size tires on a rear axle equipped with a TORSEN® differential could result in a permanent reduction in effectiveness. This loss of effectiveness does not affect normal driving and should not be noticeable to the driver.

    Manual transmission
    Using the Clutch Manual transmission vehicles have a starter interlock that prevents starting the engine unless the clutch pedal is fully pressed. To start the vehicle: 1. Make sure the parking br ...

    Hill start assist
    WARNING: The hill start assist feature does not replace the parking brake. When you leave the vehicle, always apply the parking brake and shift the transmission into position P for automatic trans ...

    Other materials:

    Driveshaft Slip Yoke
    Driveshaft (Description and Operation)   NOTE: All driveshaft assemblies are balanced. If undercoating the vehicle, protect the driveshaft to prevent overspray of any undercoating material. The driveshaft has the following features: A tubular shaft u ...

    Installation
    Removal 1. Remove the A/C compressor (19703). For additional information, refer to Air Conditioning (A/C) Compressor-3.8L or Air Conditioning (A/C) Compressor-4.6L in this section. 2. Remove the bolt. 1. Hold the A/C disc and hub assembly (19D786) with the ...

    Engine (Installation)
    Engine WARNING: Do not operate the engine with the hood open until the fan blade has been first examined for possible cracks and separation. The 4.6L (4V) (281 CID) is a V-8 engine with the following features: dual overhead camshafts four valves per cyl ...